REFLECTOR: E/P-Mag

Scott Derrick scott at tnstaafl.net
Tue Apr 4 16:52:52 CDT 2006


You'd rather be dependent on gears, cams, breaker points and coils?

> I run dual Light Speed ignition modules ... and I must admit, it does
> concern me a bit that my cookies are in the hands of transistors and
> capacitors.  I have a dual battery installation... but still ... I think
> about it - a lot!
>
> -----Original Message-----
> From: reflector-bounces at tvbf.org [mailto:reflector-bounces at tvbf.org] On
> Behalf Of HYTEC45 at aol.com
> Sent: Tuesday, April 04, 2006 9:05 AM
> To: reflector at tvbf.org
> Subject: REFLECTOR: E/P-Mag
>
> I have been running a Light Speed ignition for over 10 years with little
> trouble.  A friend purchased a P-Mag for me as a gift which I received
> last week.  I'm really not sure what benefit I will have by running two
> electronics as of yet.  The P-Mag is self powered in the event of a
> power failure, so it will take place of my one mag.
>
> I know that the E/P-mags have had some growing problems.  Before I
> invest the time to install this, does any one have any experience,
> stories good/bad things regarding these electronic units?
>
> Thanks,
> TEC
> _______________________________________________
> To change your email address, visit
> http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html



More information about the Reflector mailing list