REFLECTOR: Stuck at KOBE

[Scott Derrick]

If your not used to hand propping an engine, you will most likely fail, 
get a pro.

MikeWatsonSpg at cs.com wrote:

> Thanks for all the suggestions on getting my starter to engage.
>
> I tried to hand prop it, but had no luck. Turning a Franklin engine
> by hand requires long arms and great strength, especially when it is hot.
>
> At this point, I believe the bendix is broken, so the only recourse I have
> is to remove it and install the old Pat Goodman starter.
>
> Skytec suggested punching out the pin that holds the bendix on the
> shaft, removing the bendix assemble then try to remove the starter. I'll
> try that tomorrow and let the group know if ti works.
>
> Mike W.
>
>
>------------------------------------------------------------------------
>
>_______________________________________________
>To change your email address, visit http://www.tvbf.org/mailman/listinfo/reflector
>
>Visit the gallery!  www.tvbf.org/gallery
>user:pw = tvbf:jamaicangoose
>Check new archives: www.tvbf.org/pipermail
>Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>