REFLECTOR: HYDRAULIC PUMP CYCLES
Laurence Coen
lwcoen at hotmail.com
Fri Nov 25 10:46:42 CST 2005
Larry,
If you remove the handle from your dump valve you will find a nut around the
valve stem. If you tighten this nut you're problem may well go away. This
solved the problem for me and is sure easy to try.
Larry Coen
N136LC SE/RG Franklin/IVO
----- Original Message -----
From: Larry Parham
To: reflector at tvbf.org
Sent: Thursday, November 24, 2005 5:45 PM
Subject: REFLECTOR: HYDRAULIC PUMP CYCLES
My hydraulic pump cycles about once a minute. I know if I adjust the set
screws on the high and low limiters that it will change the timing of the
cycles. Will this cause my gears to no act properly? And how do you adjust
to stop the cycling. N51LP RGElite--Franklin/Catto thanks
------------------------------------------------------------------------------
_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20051125/d26051ee/attachment.htm
More information about the Reflector
mailing list