REFLECTOR: Main Gear wheel well
Christopher Martin
christophercmartin at earthlink.net
Sat Jul 23 12:52:51 CDT 2005
1/2" is the minimum. I would suggest 3/4" on the side parallel to the leading and trailing edge of the wing. Most importantly, MAKE SURE YOUR TIRES ARE PROPERLY INFLATED.
Christopher Martin
christophercmartin at earthlink.net
----- Original Message -----
From:
To: reflector at tvbf.org
Sent: 7/22/2005 11:34:05 PM
Subject: REFLECTOR: Main Gear wheel well
Hello all,
I'm working on the strakes - gear well of a XL/RG. Looking at the manual I think the 1/4 " foam will be plenty of clearance for the main gear leg and well... It calls for 1/2 foam for clearance around the tire...do you the collective, that have "been there and done that" think this is enough clearance to build in for the main gear tires?
I remember reading about different size tires and problems some have experienced... I have the 6 ply Condors the Factory supplied as the tire upgrade in 2000. Any and all input would be greatly appreciated. Thanx in advance for all your help.
Larry Lambert
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20050723/9e609c1e/attachment.htm
More information about the Reflector
mailing list