REFLECTOR: Blue Mountain CHT/EGT
Dave Bertram
v350tx at comcast.net
Mon Feb 14 09:04:45 CST 2005
I used thermocouple wire from the probes to a terminal strip on the firewall
and #22 wire from there to the EFIS one. It works fine. Dave Bertram
-------Original Message-------
From: Velocity Aircraft Owners and Builders list
Date: 02/12/05 17:22:17
To: reflector at tvbf.org
Subject: REFLECTOR: Blue Mountain CHT/EGT
Tom & other BMA folks,
I'm getting ready to hook up my engine probes, and I've been reading the
discussion group and then manual, and I think I've got this sorted out but
wanted to check. The CHT probes are 'resistive' Aerosance units from BMA,
and I think I can run these straight to the E/1 with standard aircraft wire.
However, I think the EGT's should be run with thermocouple wire, but I wasn
t sure if you could just take the thermocouple wire and crimp it directly
into the E/1's analog connector or not?? Thanks for any input.
Brett
www.velocityxl.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.tvbf.org/mailman/private/reflector/attachments/20050214/3f02d0e6/attachment.htm
More information about the Reflector
mailing list