REFLECTOR: Re: smooth prime
KeithHallsten
KeithHallsten at quiknet.com
Wed Apr 20 21:53:46 CDT 2005
Below is the e-mail I received from PolyFiber.
I'm amused that the solvent-based paint is now said to be more "user
friendly" than the water-borne, since that was the whole pitch for Top
Gloss!
Keith
----- Original Message -----
From: Gregory Albarian <greg at conaircraft.com>
To: KeithHallsten
Sent: Wednesday, April 20, 2005 10:08 AM
Subject: Re: Composite finishing system
Yes, Keith, you are exactly right. You need to 2 -part Epoxy Prime and then
use a top coat urethane. We have both of these, as do other manufacturers.
You may learn about our stuff through any of our distributors or by calling
us. 1-800-362-3490
Top Gloss was discontinued a couple years. The solvent-borne urethane
system is more user friendly. Before you epoxy prime, make sure the UV
Smooth Prime is completely dry.
Call if you need us.
Regards,
Greg
----- Original Message -----
From: KeithHallsten
To: info at polyfiber.com
Sent: Tuesday, April 19, 2005 8:34 PM
Subject: Composite finishing system
I have primed the Velocity I'm building with UV Smooth Prime, intending to
use the Top Gloss system. However, your website no longer makes mention of
Top Gloss. I take it that that product did not work out. Your web page on
Smooth Prime does make mention of an epoxy primer over the Smooth Prime,
then a urethane final finish over the epoxy. However, I don't see any
information on these finish products. Am I missing something?
Keith Hallsten
More information about the Reflector
mailing list