REFLECTOR: AN washers
Al Gietzen
ALVentures at cox.net
Fri Oct 15 12:00:11 CDT 2004
Subject: RE: REFLECTOR: AN washers
Sharper endge goes down! For the bite.
Ah, yes; but it's a stress riser. In some cases you may want 'bite', but
most cases surface protection for the turning nut, and compression. I
suspect one answer doesn't fit all; and mostly it doesn't matter.
Al
-----Original Message-----
From: Al Gietzen [mailto:ALVentures at cox.net]
Sent: Fri 10/15/2004 9:52 AM
To: 'Velocity Aircraft Owners and Builders list'
Cc:
Subject: REFLECTOR: AN washers
Speaking of hardware, how many people pay attention to placing the correct
side of an AN washer down? There is one.
TEC
Not me. I'm just going to guess that one side has a sharper edge. Should it
go up?
Al
-------------- next part --------------
A non-text attachment was scrubbed...
Name: winmail.dat
Type: application/ms-tnef
Size: 4680 bytes
Desc: not available
Url : http://www.tvbf.org/mailman/private/reflector/attachments/20041015/59b2d35f/winmail.bin
More information about the Reflector
mailing list