REFLECTOR: Flat wrench
Tom Martino
tmartino at troubleshooter.com
Fri Oct 15 07:48:26 CDT 2004
I drilled my axle and used a castle nut -- is that a bad idea?
-----Original Message-----
From: Scott Baker [mailto:sbakr at comcast.net]
Sent: Friday, October 15, 2004 4:34 AM
To: Velocity Aircraft Owners and Builders list
Subject: Re: REFLECTOR: Flat wrench
For many of our younger and physically fit owners, what you say is true.
On the other hand, I've encounter more than a few Velocity models with a
very heavy nose weight - and to lift the nose off the ground was hernia
producing. Many Velocity owners (because of age or disability) simply
don't
have the physical ability to lift 100 pounds (or more!), stand on one
foot,
and push the nose wheel around with their other foot. Unfortunately,
this
important check - which really should be done during every preflight ...
really, before every flight, is often ignored.
A reminder to everyone - Nyloc lock nuts have a service life ... not in
days, but in the number of times the nut is removed and used. With each
successive use, the Nyloc nut looses some of it's griping ability.
(Some of
the A&P's out there, please correct me) I believe the recommended
maximum
cycles for Nyloc's are three (3) times, at which point they should be
replaced.
I know that some Velocity aircraft are flying with the original nylon
lock
nut - and it should not come as a surprise that the nose wheel fork
caster
tension can come loose following normal flight operations - and
especially
when the nose has a hard landing - and absolutely after any hint of a
nose
wheel shimmy.
Fixed gear model pilots are the most vulnerable - 1) because (unless you
make an access hole in the nose wheel fairing) adjusting the nut
requires
the removal of the fairing, and 2) if the tension should become loose,
that
big ole nose wheel fairing will become cocked (there is no
self-centering
mechanism like in the RG models). When the next landing comes, it will
likely invite over-stress and shimmy.
Scott B.
----- Original Message -----
From: "Scott Derrick" <scott at tnstaafl.net>
To: "Velocity Aircraft Owners and Builders list" <reflector at tvbf.org>
Sent: Thursday, October 14, 2004 10:27 PM
Subject: Re: REFLECTOR: Flat wrench
>I don't understand all this concern with the nose wheel nut?
>
> I kick the tire when I preflight to verify its not loose. Its always
> tight.
>
> I removed the fork every annual and regrease the washers, retighten
the
> nut.
>
> I think I have tightened it once other than at the annual inspection,
I
> had taxied through lots of water and snow for a couple months and it
got
> loose.
>
> I put 100 to 125 hours a year on my plane.
>
> Scott
>
_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
Visit the gallery! www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
More information about the Reflector
mailing list