REFLECTOR:INSIDE CENTER KEEL

[Ronnie Brown]

I ran most of my rear cabin wiring in the center keel.  I installed two 3/4"
ID nylon tubes, one on either side that exits at bottom of the keel, on
either side of the main gear hydraulic cylinder.

My wiring running through there includes;
strobe and nav lights power
down and up limit switches for the main gear
ELT remote activate wiring
fuel tank capacitance sensor wiring
header tank low level alarm wiring
landing light power (lights mounted on main gear)
all 4 mike and headphone jacks are located in the keel behind the
pilot/copilot seats
speed brake power and limit switch wiring
I also installed a relay rack that interfaces the control stick to the
elevator and aileron trim motors just beside the co pilot seat inside the
keel.

Lots of wasted space in the keel - use it!

Ronnie



----- Original Message -----
From: "Tom Martino" <tmartino@troubleshooter.com>
To: <reflector@www.tvbf.org>
Sent: Thursday, February 26, 2004 4:12 PM
Subject: REFLECTOR:INSIDE CENTER KEEL


| Any of you guys ever run wire inside the center keel from front to back.
I have RG but it looks like there would be room without interfering.  The
side ducts aren't conventient for all of my wiring and cable needs.
|
| _______________________________________________
| To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
|
| Visit the gallery!  www.tvbf.org/gallery
| user:pw = tvbf:jamaicangoose
| Check new archives: www.tvbf.org/pipermail
| Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
|