REFLECTOR:Re: Jeff Rose (ElectroAir) Ignition Question

[Wayne Lanza]

--Apple-Mail-10-659181385
Content-Transfer-Encoding: quoted-printable
Content-Type: text/plain;
	charset=ISO-8859-1;
	format=flowed

Hi Jack,
  If you decide to use Jeff Rose's ignition you will need to add an=20
Ignition breaker to
your prewired XL power panel, then move the wire on the panel marked=20
"Rt Mag" to
the adjacent terminal marked "Rt Ignit". The "Rt Mag" wire on the=20
firewall will then
source +12V to power the ignition instead of grounding the mag to shut=20=

it off. No
further changes or additional wiring is needed, the changes can be done=20=

in 15 min.
  I designed the XL power panel to support either a two mag or=20
mag/ignition set up.
The schematic and power panel docs should reference the changes - if=20
not call me...
  Installing the ignition is easy but there is one caveat, the timing=20
wheel for the 6 cyl
engine goes behind the flywheel, i.e. you gotta remove the prop. As I=20
understand it,
Jeff is no longer supplying the mag hole pickup for the Lycoming. The=20
timing wheel
installation and associated wiring is not difficult and remember that=20
you will need to
tap the manifold pressure line for the ignition.

See you at Sun-N-Fun,
Wayne Lanza
Composite Design
_________________________________________________________________


On Wednesday, Feb 25, 2004, at 17:32 US/Eastern, AnnSam wrote:

> I=A0originally had two slick mags. I replaced the right mag. with a =
Jeff=20
> Rose Ignition System after about 250 hrs. The install was easy,=20
> however, you have to run some new wires to provide the electronic ign.=20=

> system with 12 volts and ground.
> -----Original Message-----
> From: reflector-admin@tvbf.org [mailto:reflector-admin@tvbf.org]On=20
> Behalf Of Jack Sheehan
> Sent: Wednesday, February 25, 2004 2:05 PM
> To: reflector@tvbf.org
> Subject: Re: REFLECTOR:Jeff Rose (ElectroAir) Ignition Question
>
> Bob,
> Have you always had the electronic ignition? or did you add it after ?=20=

> How difficult was the install if you did it later?
> Jack
> N55XL
>

--Apple-Mail-10-659181385
Content-Transfer-Encoding: quoted-printable
Content-Type: text/enriched;
	charset=ISO-8859-1

Hi Jack,

 If you decide to use Jeff Rose's ignition you will need to add an
Ignition breaker to

your prewired XL power panel, then move the wire on the panel marked
"Rt Mag" to

the adjacent terminal marked "Rt Ignit". The "Rt Mag" wire on the
firewall will then

source +12V to power the ignition instead of grounding the mag to shut
it off. No

further changes or additional wiring is needed, the changes can be
done in 15 min.=20

 I designed the XL power panel to support either a two mag or
mag/ignition set up.

The schematic and power panel docs should reference the changes - if
not call me...

 Installing the ignition is easy but there is one caveat, the timing
wheel for the 6 cyl

engine goes behind the flywheel, i.e. you gotta remove the prop. As I
understand it,

Jeff is no longer supplying the mag hole pickup for the Lycoming. The
timing wheel

installation and associated wiring is not difficult and remember that
you will need to

tap the manifold pressure line for the ignition.


See you at Sun-N-Fun,

Wayne Lanza

Composite Design

_________________________________________________________________



On Wednesday, Feb 25, 2004, at 17:32 US/Eastern, AnnSam wrote:


=
<excerpt><fontfamily><param>Arial</param><color><param>0000,0000,FFFF</par=
am><smaller>I=A0originally
had two slick mags. I replaced the right mag. with a Jeff Rose
Ignition System after about 250 hrs. The install was easy, however,
you have to run some new wires to provide the electronic ign. system
with 12 volts and ground.</smaller></color></fontfamily>

<smaller>-----Original Message-----

<bold>From:</bold> reflector-admin@tvbf.org
[mailto:reflector-admin@tvbf.org]<bold>On Behalf Of </bold>Jack Sheehan

<bold>Sent:</bold> Wednesday, February 25, 2004 2:05 PM

<bold>To:</bold> reflector@tvbf.org

<bold>Subject:</bold> Re: REFLECTOR:Jeff Rose (ElectroAir) Ignition
Question


<fontfamily><param>Arial</param>Bob,</fontfamily></smaller>

<fontfamily><param>Arial</param><smaller>Have you always had the
electronic ignition? or did you add it after ? How difficult was the
install if you did it later?</smaller></fontfamily>

<fontfamily><param>Arial</param><smaller>Jack</smaller></fontfamily>

<fontfamily><param>Arial</param><smaller>N55XL</smaller></fontfamily>


</excerpt>=

--Apple-Mail-10-659181385--