REFLECTOR:valve

[Chuck Jensen]

Courtesy of Andy Millin, a diverting valve was from McMaster-Carr is part
number: 4373K52.  It's brass so it'll weigh a couple more oz. than an
aluminum valve but I looked and never found an Al valve.  If you want to
check Andy's most excellent builder's site at www.kal-soft.com/velocity I
think you'll find it helpful to see how a blower and cooler are formed up
when it's done with care and thought.  

Chuck

-----Original Message-----
From: reflector-admin@tvbf.org [mailto:reflector-admin@tvbf.org]On
Behalf Of Larry Richter
Sent: Tuesday, February 10, 2004 7:30 PM
To: reflector@tvbf.org
Subject: REFLECTOR:valve


A short time ago there were discussions regarding an oil cooler inside 
the cabin as a heater with the oil being diverted with a valve.  Does 
anyone have a part number or source for such a valve:  two into one, 
approx. 90 degree throw, adaptable to a cable control, #8 or 3/8 pipe 
thread?
Thanks.
ljr


_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector

Visit the gallery!  www.tvbf.org/gallery
user:pw = tvbf:jamaicangoose
Check new archives: www.tvbf.org/pipermail
Check old archives: http://www.tvbf.org/archives/velocity/maillist.html