REFLECTOR:Vance's Sight Gauges

[Brett Ferrell]

I think I followed his instructions to the letter (at least I meant too),
although I think I put a few dobbs of bondo or 5 minute epoxy on the corners
to hold pressure while it cured.  I didn't pull on it afterward, though, I
just went ahead with the BID layup onto the surface surounding the bubble
and squeezed some more flox into any obvious gaps around the edge....  Fuel
hasn't hit it yet, though, so your mileage may vary.

Brett

----- Original Message ----- 
From: "Craig and/or Denise Woolston" <cdwoolston@earthlink.net>
To: "reflector" <reflector@awpi.com>
Sent: Tuesday, September 16, 2003 4:55 PM
Subject: REFLECTOR:Vance's Sight Gauges


> For those that have Vance's sight gauges, what did you use to glue the
clear
> plastic bubble to the white base?  I tried Velocipoxy with flox and
roughed
> the surface with 220 and got very poor adhesion (I just popped them loose
> with very little effort).  Mostly I believe because of poor contact
> pressure.  Was curious how others had done what Vance describes as such
any
> easy process.
>
> Craig
>
> !----------------------------!
> ! Craig Woolston             !
> ! XL-FG in Palmdale, CA      !
> ! cdwoolston@earthlink.net   !
> !----------------------------!
>
> _______________________________________________
> To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  www.tvbf.org/gallery
> user:pw = tvbf:jamaicangoose
> Check new archives: www.tvbf.org/pipermail
> Check old archives: http://www.tvbf.org/archives/velocity/maillist.html
>