REFLECTOR:Finishing work on fastbuilds?
reflector@tvbf.org
reflector@tvbf.org
Tue, 24 Jun 2003 15:22:18 EDT
--part1_38.3a8b9f1f.2c29feea_boundary
Content-Type: text/plain; charset="US-ASCII"
Content-Transfer-Encoding: 7bit
Brett, I would say "free of major defects". Each set is hand made and
obviously vary from set to set a bit. The wings did not need very much, the strakes
a bit more, both on bottom and top. Fuselage needed little except in those
areas where it has been cut, like around NACA s and so on. Have to put in a
small "radius" where the strake joins the fuselage, on both bottom and top.
Even after finishing at Velocity and painting I still notice a few low spots
when I look at the plane in bright light.
Bob Wood
--part1_38.3a8b9f1f.2c29feea_boundary
Content-Type: text/html; charset="US-ASCII"
Content-Transfer-Encoding: quoted-printable
<HTML><FONT FACE=3Darial,helvetica><FONT SIZE=3D2 FAMILY=3D"SANSSERIF" FACE=
=3D"Arial" LANG=3D"0">Brett, I would say "free of major defects"=
. Each set is hand made and obviously vary from set to set a bit. The wings=20=
did not need very much, the strakes a bit more, both on bottom and top. Fuse=
lage needed little except in those areas where it has been cut, like around=20=
NACA s and so on. Have to put in a small "radius" where the strake joi=
ns the fuselage, on both bottom and top.<BR>
<BR>
Even after finishing at Velocity and painting I still notice a few low spots=
when I look at the plane in bright light. <BR>
<BR>
Bob Wood</FONT></HTML>
--part1_38.3a8b9f1f.2c29feea_boundary--