REFLECTOR: Exhaust systems

Alexander Balic reflector@tvbf.org
Fri, 11 Jul 2003 22:46:03 -0500


I agree, the pickup should work on any high tension lead, regardless of the
source... unless the shielding on the wire is so good that it prevents the
pickup from grabbing enough flux to fire the strobe.....

-----Original Message-----
From: reflector-admin@tvbf.org [mailto:reflector-admin@tvbf.org]On
Behalf Of Scott Derrick
Sent: Friday, July 11, 2003 9:28 PM
To: reflector@tvbf.org
Subject: Re: REFLECTOR: Exhaust systems


Rose must have some way of timing it?

Any induction type timing light will work?? How could it not?  You just
clip the inductor over the plug wire, connect up your power(battery) and
that's it?  It works with any spark plug wire, it doesn't matter if it
powered by a mag, mechanical distributor or an EI.

I know the engine must be running to do this which is a drag, but its
doable.

Scott

John Dibble wrote:
> Thanks.  Lightspeed says to use a timing light which is what I would
expect.  I was told by Rose,
> however, that a timing light can not be used with my Rose EI, so I'm
looking for other ways to
> confirm the correct timing.
>
> John
>
> Scott Derrick wrote:
>
>
>>I don't know if you have the lightspeed EI or not.
>>
>>Their manual is online at http://www.lightspeedengineering.com/  and has
>>detailed instructions on how to time any ignition.
>>
>>Scott
>>
>
>
>
> _______________________________________________
> To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector
>
> Visit the gallery!  tvbf:jamaicangoose
>


_______________________________________________
To change your email address, visit
http://www.tvbf.org/mailman/listinfo/reflector

Visit the gallery!  tvbf:jamaicangoose