REFLECTOR:Exhuast systems
John Dibble
reflector@tvbf.org
Tue, 08 Jul 2003 09:42:35 -0400
Do the prop stains indicate inadequate mixture leaning?
John
Jim Agnew wrote:
> Scott,
>
> Without slip joints you will almost always get cracking
> because each cylinder is expanding at a different rate due
> to uneven heating. As far as no stains on the prop, I have
> two to one on my IO-360 rear facing except that the rear
> end of the pipe has a 90 degree elbow which has been milled
> off flush with the bottom of the pipe leaving a large oval
> hole with a tip down end. This mixes the exhaust with the
> air passing around the fairing and turns it down slightly.
> At most after several hours I get a slight haze on the prop
> that just wipes off. I can send you a picture directly if
> you like.
>
> Jim
>