[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
REFLECTOR: Caenter spar Sweep
I am Installing my center spar on an XL 173 and
I am having problems getting it in right.
To get the Equal Dimension at the outer bolt
holes I have to shim about 1/4 of an Inch
out on the
left side of the bulk head .I do have the Engine bulk head in and it is right on
the money Dimensionally from the center bolt hole, Equal dimensions on both
sides.
The manual also does not say to center the spar
in the fuselage I assume you just would do it
out common sense .But you know what they say
about assuming.The only other way to get
the required dimension is not center the spar
and then it ends up about 1./14 in off set and
that just does not seam right .
Any Help
Ron N34CV