Re: REFLECTOR: RE: Aileron control torque bearing

["Bill Eck" <billeck@ix.netcom.com>]

-----Original Message-----
From: J42AL@aol.com <J42AL@aol.com>
To: reflector@awpi.com <reflector@awpi.com>
Date: Friday, March 26, 1999 6:36 PM
Subject: REFLECTOR: RE: Aileron control torque bearing
    Would love to have a set.  Are these like the one's described by
Simon??

Bill  Eck
9627 Spring Loop Drive
Germantown, TN 38139

billeck@ix.netcom.com



>As you know there was an incidence in the past, where the forward aileron
>control torque bearing came loose. The factory has recommended replacement
of
>original flat head screws with round head screws.
>
>I have created machined, aluminum (0.115") thick cover washers for both
front
>and rear aileron control torque bearings that cover the entire front of the
>bearings. It does sandwich the bearings between my washers and the mounting
>brackets over the entire flange surface of the bearing. They fit the
original
>threaded mounting holes. you would be able to use the original screw type (
>flat head on rear) and factory recommended (round head on forward).
>
>For those of you who are interested I can fabricate a set for you. Cost:
>$26.00 per set.
>
>Direct any inquiries directly to me.
>
>John Leder
>XL RG (to be soon N203SM)
>