[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
REFLECTOR: Bulkhead Installation
Do most people do the finger
Micro Joint and the Glass Tape layup seperately or together at the same time?
I've just used structural adhesive to hold the
firewall in place.. A few dobs here and there.. I was going to micro it
and
the main gear bulkhead in tommorrow. Also,
should I use micro made with Velocipoxy or the standard stuff
(epolite/safetypoxy/ezpoxy) ? I didn't know, thought maybe a more flexible epoxy
was required..
I've also noticed getting the
Main Gear bulkhead in is a pain.. It sits right behind the foam line and then
rolls forward
onto the foam line..(RG version) It's
required some sanding thusfar to get it not to bind.. It'll take alot of micro
in its
joint for
sure!
Any thoughts on this area are
appreciated..
David Cowan
Std RGE