Re: REFLECTOR: Mg Bulkhead; Plywood Direction

["lawrence epstein" <ljepstein@hotmail.com>]

>
>>     Is the plywood grain direction crucial on the main gear
>> bulkhead?  Anyone?  I'm building an RG
>> and have just jigged up the bends with 5 minute.. However I cut the
>> plywood with the grain running
>> vertically.. Is that OK?

David->


My suggestion, on questions like this is to use the phone whenever 
possible, ie; call the factory.

They hve always been very helpful, particularly on specific questions 
related to the manual and technique.  

Larry Epstein
173 FGE

______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com